Stop deburring by hand. Let the spindle finish the part.
Manual deburring is slow, inconsistent, and the first thing that scraps a good part. We bring NOGA MT's automated deburring and finishing system — UFIBER nano-ceramic fiber brushes plus the UBURR and USPOT tooling — so edge-break, polish, and back-machining happen in-cycle on your CNC or robot cell. Repeatable Ra, no flipped parts, no bench.
UFIBER ceramic fiber brushes
Nano-bonded ceramic fibers hold their cutting edge far longer than nylon-abrasive or micro-bond brushes, so surface roughness stays consistent and tool life climbs. Built to run in CNC machines and robot arms.
- Surface, cross-hole, point & end-face brush types
- Aluminum, stainless, Inconel, titanium, composites, hardened
- RPM controls effective diameter via centrifugal spread
UBURR through-hole deburring
Precision cutting blades on the MT DURASHIELD tool-holder remove front and rear burrs in one pass — repeatable chamfers with no part flip. Proven on hardened tool steel up to 60 HRC.
- Clean 0.2 × 45° chamfers, front and back
- DURASHIELD holder for stable, repeatable runs
- Single-setup, high-volume hole finishing
USPOT spot-face & counterbore
A hydraulic mechanism drives controlled insert movement to reach hidden and back-side surfaces — turning spot-facing and counterboring into one smooth automated CNC operation instead of a second setup.
- Reaches back-side and hidden faces
- Stable in interrupted cuts
- Fewer setups, better surface quality
From rough edge to finished part — in one cycle
Watch the UFIBER brush break edges, knock down burrs, and bring up the surface in the same program that machined the part — no second op, no flipping, no bench. The fibers spread under speed to reach into the bore and across the face, holding a consistent finish part after part.
- Runs in-cycle on the CNC — or unattended in a robot cell
- Repeatable Ra, batch to batch, with no operator touch
- Same tool deburrs, polishes, and finishes
The UFIBER Smart Guide is NOGA MT's AI assistant for the UFIBER line. Describe your material, feature, and burr condition and it recommends the brush type, grit, speed, and approach — and troubleshoots finish problems. Find the spec there; we supply the tooling, build any custom shank, and dial it in on your machine.